Door locks
What actually separates these two ABUS rim locks?
Both mount on the inside face of the door, with a key outside, a thumbturn inside, a two-turn deadbolt and two keys supplied, and both are sold for the closing edge of an entrance door. The difference is in what each listing publishes: the 2110 states its five-pin cylinder, the door thickness it takes and the 32 mm (1.26 in) bore; the 2130 states its white finish.
| Compared on | 2110 | 2130 |
|---|---|---|
| Intended door | Entrance door | Entrance door |
| Bolt | Two-turn deadbolt | Two-turn deadbolt |
| Cylinder | 5-pin, stated by ABUS | Not stated |
| Inside | Thumbturn | Thumbturn |
| Outside | Key | Key |
| Door thickness | 35–50 mm (1.38 to 1.97 in) stated | Not stated |
| Bore required | 32 mm (1.26 in) stated | Not stated |
| Keys supplied | 2 keys | 2 keys |
| Finish | Not stated | White |
| Listed on amazon.com | No | Yes |
A tick marks the better answer on that line only. Counting ticks does not decide the page — the two verdicts below do, because these products answer different questions.
No amazon.com listing was found for this one. We hold references for other markets but none for the United States, so it may not be buyable here — which is the first thing to weigh against anything below.
Buy the 2110 if you want to check before ordering: it publishes the door thickness it takes — 35 to 50 mm (1.38 to 1.97 in) — and the 32 mm (1.26 in) bore, which you can hold against your actual door.
Buy the 2130 if the inside hardware should stay white, and measure your door first: its listing publishes neither the door thickness nor the bore.
Because two locks at different heights spread the load across more of the frame, and a door forced at one point still holds at the other. It is the same reasoning as a multipoint lock, arrived at without replacing the door.
No, and nothing on this page does. A rim lock is bolted to a strike, and a strike held by two short screws in a soft lining is what fails. Long screws into the structural stud behind it cost almost nothing and change the outcome.
Rim lock with thumbturn inside · key outside · 5-pin cylinder · doors 35–50 mm (1.38 to 1.97 in) · 32 mm (1.26 in) bore
ABUS's additional rim lock: a thumbturn inside, a key outside, and a five-pin cylinder. Stated for doors 35 to 50 mm (1.38 to 1.97 in) thick with recesses up to 21 mm (0.83 in), and needing a 32 mm (1.26 in) round hole for the cylinder.
Best for: Securing the closing edge of a front door against levering, on a door of ordinary thickness.
Rim lock, entrance doors · thumbturn inside, key outside · two-turn deadbolt · 2 keys
The 2130 is ABUS's entrance-door rim lock: a sturdy two-turn deadbolt, a thumbturn on the inside and a key from outside, supplied with two keys, in white.
Best for: The same job as the 2110 on an entrance door, where the inside hardware should stay white.
≈ $115
